Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Guide
Please read all information before installing the lamps and keep this sheet for future reference.
• These lamps are direct replacements for 59W/54W/F96T8/IS lamps.
• Dimmable when used with compatible dimming ballast.
• Compatible with electronic instant start ballast.
• Risk of electric shock- Suitable for damp locations.
• Any modi cations to this product will void the warranty.
• This lamp may not be compatible with all ballasts, go to www.westinghouselighting.com for compatibility information.
IMPORTANT SAFETY INFORMATION:
Do not install this lamp in a pre-heat luminaire .
This lamp only operates on electronic ballast. If the lamp does not light when the luminaire is energized, remove lamp from luminaire and contact lamp
manufacturer or quali ed electrician.
Caution Rick of re-If the lamp or luminaire exhibits undesirable operation (buzzing, Flickering, etc.) Immediately turn power o , Remove lamp from luminaire and
contact manufacturer.
This product may cause interference to radio equipment and should not be installed near maritime saftey communications equipement or other critical navigations
or communication equipment operating between 0.45-30MHz
This device is not intended for use with emergency exits.
OPERATE WITH METAL FIXTURE ONLY:
Lamps must be operated within an ambient xture temperature of -22°F and 133°F to ensure UL compliance.
INSTALLATION INSTRUCTIONS
Make Sure Power is OFF
Insert the Westinghouse LED
replacement lamp.
NOTE: Please insert lamp per
label direction (on lamp back)
to make sure the
light-producing side of the
LED tube is facing downwards.
Remove the di user, lens
cover or louver (if provided).
Fluorescent lamps to be
replaced with Westinghouse
TLED T8 lamps are shown
above.
Repeat steps 3 and 4 as
needed for additional lamps.
Replace the di user, lens
cover or louver (if removed in
step 2).
2
Then, remove the lamp from
the lamp holder.
Power ON.
ESF-WH-023
Publicidad
