Care And Maintenance - Cressi-sub B.C.’S JACKETS Manual De Instrucciones

CARE AND MAINTENANCE

After each use, carry out the following operations:
• Remove the tank and rinse the jacket with fresh water,
both outside and inside, allowing water to enter the ID
hose and the bag through the deflation or the over-
pressure valve.
• Drain any water left in the jacket and allow it to dry in the
open air with open valves.
• Once it is completely dry, close all valves, lightly inflate it
(using the mouth-inflation piece located in the by-pass)
and store it in a cool and dry place.
If the device is not used for a long time, lubricate the hose
connection and the collar with silicone grease and
spread the ID hose with talcum powder.
The CRESSI-SUB jackets are in conformity with the
EN 250 - EN 1809 standards and have been given the
CE safety certification (CE 0474).
A label bearing the following information is sewn under
the lateral or rear pocket:
WARNING!
THIS IS NOT A LIFE JACKET AND DOES NOT ASSURE
THE DIVER OF KEEPING HIS/HER HEAD OUT OF THE
WATER
- To use this jacket, a specific course held by a certified
instructor must be attended.
- In case of emergency, face up buoyancy at the surface
may not be provided to all users and in all conditions.
- Before use, check for good condition and proper
operation of the jacket and make sure that no holes o
damages are present.
- Follow all the instructions in the Owner's Manual.
- Do not inhale gases from inside the bag.
- Do not remove from the jacket.
Model:_______ Manufacturing year:_______
Table showing the buoyancy values (expressed in
Newtons) for each jacket size.
Pictogram showing the max. tank capacity in litres.
English 21