Safety Guidelines - Altrad BELLE MAXIPAVE Manual Del Operador

EXCELLENT CHOICE! The "MAXIPAVE" you have chosen will give many years of trouble free operation with only basic periodic
maintenance required.
Safe operation depends on reliable equipment and the use of proper operating procedures. Performing the checks and services
described in this manual will help keep your machine in good condition. These recommended operation procedures will help you to
avoid unsafe practices. Safety notes have been included to help you avoid injury and prevent damage to the equipment. These notes
are not intended to cover all eventualities; it is impossible to anticipate and evaluate all possible methods of operation. Therefore,
you are the only person who can guarantee safe operation and maintenance. It is important that any procedure not speci cally
recommended in this manual be thoroughly evaluated from the standpoint of safety before it is implemented.
The product can be at risk. The machine or yourself can be damaged or injured if procedures are not
CAUTION
carried out in the correct way.
WARNING
The life of the operator can be at risk.
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
WARNING
this manual.
KNOW how to safely use the unit's controls and what you must do for safe maintenance. (NB Be sure that you know how to switch the
machine off before you switch on, in case you get into dif culty.)
ALWAYS wear or use the proper safety items required for your personal protection. If you have ANY QUESTIONS about the safe use
or maintenance of this unit, ASK YOUR SUPERVISOR OR CONTACT: Altrad Belle (UK): +44 (0) 1298 84606
Safety Guidelines ...................................................................................................................................................................................... 9
Safety Checks ......................................................................................................................................................................................... 10
Technical Data ......................................................................................................................................................................................... 10
Operating Instructions ..............................................................................................................................................................................11
Warranty ...................................................................................................................................................................................................11
Pre-start Inspection
- INSPECT your machine. Have any malfunctioning, broken or missing parts corrected or replaced before use.
- VERIFY that all the instruction and safety labels are in place and readable. These are as important as any other equipment on the
machine.
- CHECK for WARNING tags placed on the machine. DO NOT operate the equipment until repairs have been made and the
WARNING tags are removed by authorized personnel.
Operating
- NEVER use the equipment if you are unwell, or under the in uence of alcohol or drugs.
- Place material between knives, resting the material level on Stone Rails. Place material between knives, resting the material level
on Stone Rails. Bring the operating lever 45° to the mainframe, and adjust blade gap so that the top knife is just touching the
material. When the lever is pulled down, the material will be cut. This also gives adequate clearance when loading the machine
with similar material.
Maintenance
- ALWAYS replace damaged or lost decals. Refer to the Parts Manual for the proper location and part number of all decals.
Introduction
Altrad Belle reserves the right to change machine speci cation without prior notice or obligation.

Safety Guidelines

WARNING
Contents
9