Environment Listen Management; Block Calls; Change Code; Dial Number - Tyco BTEL-3G Manual De Usuario

Environment Listen Management

This function can be activated in order to hear what is happening in the protected area through a sensitive microphone.
To enable/disable the open microphone, type the following keypad sequence:

Block Calls

Ë Ë Ë Ë Ë
Once you are aware of the situation that caused the alarm, or in case of a false alarm,you can block the dialer (and therefore any calls
or text messages,even those in progress). To do this is sufficient,after entering the user menu,press
I I I I I CAUTION:
— To block calls, you can also use input no. 4 (L4) when suitably connected and programmed.
— If you enter the User PIN during a call to access the User Menu (yellow LED lit), the key inputs will not be
confirmed by a tone but the code will still be accepted and you will access the menu at the end of the call. You
cannot enter the User PIN at the beginning or end of a call (yellow LED switching).
— If "Call Confirm Result" is enabled, you need to press
received the voice message and before the dialer ends the call) to confirm reception of the voice message
and not receive any more calls at this number (but without blocking the dialer).

Change Code

The factory default User PIN is 00000. To change it, type the following keypad sequence:
where <New PIN> is a number of 5 digits.

Dial Number

To call a telephone number in live mode, type the following keypad sequence:
for <Telephone Number>, type the number that you are calling (up to 16 digits).

Phone Book Management

I I I I I ATTENTION - To exit from the Phone Book Management menu and go back, press the
Write Phone Book
To enter a telephone number, type the following keypad sequence:
where <Position no.> is a number from
5 a 1 3470 e e e e e
I I I I I The dialer can store up to 9 telephone numbers, each up to 16 digits long.
Read Phone Book
To check the programmed phone number, type the following keypad sequence:
where <Position no.> is a number from
(position no. 3) displayed, type
3G/2G Telephone dialler
1 3 1
1 3 9
( (
( ( (
Ë Ë Ë Ë Ë
( ( (
( (
3
<New PIN><Repeat New PIN>
Ë Ë Ë Ë Ë
4
<Telephone Number>
5 a
<Position no.> <Telephone Number>
1 9
to , while <Telephone number> is a number of up to 16 digits. For example
(the telephone number entered in the phone book in position no. 1 is 3470).
5 b
1 9
to . If, for example, you want the third programmed telephone number
5 b 3
.
( (
( ( (
to Enable
to Disable
* #
or on a PSTN or GSM telephone (after having
e
Ë Ë Ë Ë Ë
<Position no.>
2.
f f f f f
key.
e
EN
11