Preventive Maintenance - Schulz AP70 Manual De Instrucciones

7. PREVENTIVE MAINTENANCE

1. CLEANING OF THE FILTER
A.
To remove dirt from the dust collector, open up the appliance as shown in fi gures 7.1 and 7.2.
B.
Remove the dust collector, protection and then the fi lter.
C.
Empty the dust collector.
D.
Clean the fi lter as follows:
• Brush the fi lter to remove the dirt.
• Shake all the fi lter for the dirt to come off.
• Wash the fi lter in warm water with mild soap or detergent. If necessary, also wash the dust collector.
• Make sure the fi lter is completely dry and free of residues before putting it back in place.
E.
Replace the fi lter at every 6 to 9 months or whenever necessary. Spare fi lters are available at a SCHULZ
dealer.
ATTENTION
water.
Note: Turn of the vacuum cleaner and disconnect the plug from the power supply before beginning any cleaning
or maintenance job in the product.
2. CLEANING OF THE PLASTIC PARTS
A.
Use only mild soap and a cloth moistened in warm water to clean the plastic parts of the device.
B.
Avoid any other kind of detergent, cleaner or solvent because these products may contain chemicals that
could damage the plastic parts.
Always operate the vacuum cleaner with the fi lter. Never sink the vacuum cleaner in
Protection Dust
nozzle Collector
FIGURE 7.1 - MODEL AP 70
Dust
Protection
Collector
FIGURE 7.2 - MODEL AP 120
Protection Filter Motor
Filter
20
Motor