Put the switch in the "ON" position; the camera is ready to work.
The red start-up indicator light will blink and the LCD display will count down 5 seconds. This
interval allows you time to close the camera front cover and leave the monitored area.
Once in the ON mode, the camera will take photos or videos according to its current
parameter settings.
NOTE: the camera comes pre-programmed with factory default settings. So for test purpose,
you only need to insert the SD card and AA batteries then power on the camera (switch in
the ON position).
7.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera. Please note that even in OFF
mode, the camera still consumes power at a very low level. Therefore, please remove the
batteries if the camera will not be used for a long time.
The OFF mode is the "safe mode" for actions such as: replacing the SD card or batteries, or
transporting the camera.
You will also use the OFF mode if you connect the camera to a computer's USB port later to
download your photos/videos.
7.3. WIFI connection
Before using the WIFI function, please install the PIE1045 application on your smartphone.
Download the application by searching for "PIE1045" on GOOGLE PLAY (for Android
smartphones) or on the APPLE STORE (for IOS smartphones).
Connection steps:
- Activate the WIFI:
- When the device is in SETUP mode and on "Take a photo" or "Start a video",
press and hold the key for 3 seconds. The WIFI connection interface appears
on the LCD screen. The indicator lights at the top of the device flash.
- When the device is in working mode (selector in the ON position), use the
supplied remote control to activate the WIFI. Press the ON button on the
remote control for about 3 seconds, then release it to wake up the camera and
start the WIFI connection. The WIFI connection interface appears on the LCD
screen. The indicator lights at the top of the device flash.
PIE1045 - Indice B – Mars 2020
Camera WIFI connection interface
SSID:PIE1045
PWD:12345678
25/76