Set Time/Power Level; Multiple Stage Cooking; Program Cooking Presets - Buffalo G316 Manual De Instrucciones

Telephone Helpline: 0845 146 2887

Set Time/Power Level

To set a basic cooking program:
Press POWER LEVEL to set the power level.
1.
Note:
Press POWER LEVEL
ONCE for High TWICE for Medium
Use the number buttons to enter the cooking time.
2.
Note:
For example, to enter 3 minutes, press
To enter a time less than 1 minute, only key in the amount of seconds. Do not key in
Press the START button to commence cooking.
3.
Press the STOP/RESET
4.

Multiple Stage Cooking

The Buffalo Commercial microwave can be programmed with up to 3 different cooking stages to run in sequence:
Stage 1
Press POWER LEVEL to set the power level.
1.
Use the number buttons to enter the cooking time.
2.
Stage 2
Press POWER LEVEL to set the power level.
3.
Use the number buttons to enter the cooking time.
4.
Stage 3
Press POWER LEVEL to set the power level.
5.
Use the number buttons to enter the cooking time.
6.
Press the START button to begin cooking.
7.
Note:
To begin cooking after Stage 2, press the START
Press the STOP/RESET
8.

Program Cooking Presets

Frequently used Single or Multiple Cooking Stages can be saved to a Preset number button. Each key is preset with the following default cooking times:
Key Number
Preset Cooking Time
(min:sec)
To program and store a Preset:
Press the PROGRAM button.
1.
Press the number button where the preset is to be stored.
2.
Select the power level.
3.
Enter the cooking time.
4.
Repeat steps 3 and 4 as necessary for multiple stage cooking.
5.
Press and hold the PROGRAM
6.
Press the STOP/RESET
7.
OR
Press the START button to begin cooking with that preset.
:
THREE times for Low
for the number of minutes, and
button to stop cooking at any time.
button to stop cooking at any time.
1 2 3
0:10 0:20 0:30
button to save the Preset Program.
button to return to Standby mode
button instead of entering Stage 3.
4 5
0:45 1:00 1:30
for the number of seconds.
minutes.
6 7 8
2:00 2:30
UK
9 0
3:00 3:30
3