Electrical Connection - Beem Megatherm Mix & Cook 6 in 1 Manual De Instrucciones

EN
CAUTION
► Do not use sharp objects or abrasive
cleaning agents to clean the surfaces.
► When using for prolonged periods of
time, allow the appliance to cool down
occasionally to avoid overheating.
► The jug is not suitable for ovens or
microwave ovens.
► Never lift or move the appliance with
the mains cable.
Requirements for the place of
peration
For safe and trouble-free operation of the
appliance, the place of operation must sat-
isfy the following requirements:
■ Place the appliance on a firm, dry, flat,
waterproof and heat-resistant surface.
■ Do not install the appliance in a hot, wet
or very humid environment.
■ The mains socket must be easily acces-
sible and allow fast disconnection in the
event of an emergency.
■ The surface finishes on furniture may
contain substances that can be detri-
mental to the feet of the appliance. If
necessary, place a mat under the feet of
the appliance.
BEEM - Elements of Lifestyle
Megatherm Mix & Cook 6 in 1

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions must
on the electrical connection be observed:
■ Before connecting the appliance, com-
pare the connection data (voltage and
frequency) on the rating plate with those
of your mains power supply. This data
must correspond in order to avoid dam-
age to the appliance. If in doubt, ask
your electrical appliance retailer.
■ The mains socket must be protected by
at least a 16 A automatic circuit breaker.
■ Ensure that the mains cable is undam-
aged and is not laid over sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Place the cable in such a way as to
avoid danger from tripping.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
23