Power Sources - memorex MVD2009CB Manual De Instrucciones

Inserting Batteries
Open the battery compartment cover in the direction of
the arrow.
Install two "AAA" batteries (not supplied), paying
attention to the polarity diagram in the battery compart-
ment.
Replace the compartment cover.
Operation
• Aim the remote control at the remote sensor and
press control buttons to operate.
• Operate the remote control within 30° angle on
either side of the remote sensor, up to a dis-
tance of Approx. 5 meters.
NOTES:
• Do not leave the remote control unit exposed to direct
sunlight or in hot or humid places.
•
The remote control unit uses infrared beams to
transmit signals, so sunlight or fluorescent light on the
remote sensor may shorten operating distance.
• Incorrect use of batteries may cause them to leak or
burst. Read the battery warnings and use the batter-
ies properly.
•
Do not mix old and new batteries.
•
Remove batteries if the remote control will not be
operated for an extended period of time.
5G60701A E P06-11
Remote control
Approx. 5 meters
11

Power sources

TO USE AC POWER
Use the AC polarized line cord provided for operation
on AC. Insert the AC cord plug into a standard 120V
60Hz polarized AC outlet.
NOTES:
•
Never connect the AC line cord plug to anything other
than the specified voltage (120V 60Hz). Use the
attached power cord only.
•
If the polarized AC cord does not fit into a
nonpolarized AC outlet, do not attempt to file or cut
the blade. It is the user's responsibility to have an
electrician replace the obsolete outlet.
•
If you cause a static discharge when touching the
unit, and the unit fails to function, simply unplug the
unit from the AC outlet, wait a few minutes, and
plug it back in. The unit should return to
normal operation.
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other)
TO USE DC POWER
By using the DC car cord supplied with the TV/DVD,
you can operate this TV/DVD from a cigarette lighter
socket in any car that utilizes a negative ground
system.
The fused 12V DC car cord has been designed to
power the set from the external DC power (12 volt
negative ground) through the TV/DVD DC input jack.
Connect the smaller plug on the end of the cord to the
DC input jack on the rear of the TV/DVD, then insert
the other end of the car cord into the cigarette lighter
socket of your car. Make sure that the cord makes a
firm connection. It may be necessary to try several
insertions, rotating the plug for proper electrical
connection.
TV/DVD
To DC Input Jack
6/11/03, 6:08 PM
AC Outlet
CAR
To Cigarette
Lighter Socket
Car Cord (supplied)
11