Cleaning And Care - Reer PIA Manual De Uso

Renewed boiling becomes possible only after the automatic switchoff mecha-
nism has cooled down sufficiently. This may take a couple of minutes, depending
on the operating and surrounding temperatures.
Drying protection: In case your device is in operation with too little or no water,
the drying protection prevents overheating, but doesn´t turn it off completely. The
device must be turned off manually by all means! Let it cool down (10 mins) before
refilling. After cooling down the device is ready for operation.
Always unplug first. When the heating bowl has cooled off, it can be wiped out
with a damp cloth. For decalcifying the appliance use commercially available fluid
Decalcifiers. Follow the respective instructions for use! Limescale can also be dissol-
ved by a vinegar-water solution (equal parts household vinegar and water) which
is brought to boil briefly. If there is a lot of limescale, the above mentioned process
must be repeated. Do not leave the heating bowl unattended as the vinegar-water
mixture can foam over. Leave the solution in the heating bowl for a few moments
longer after brief boiling and then pour it out. Wipe out the heating bowl after the
de-calcifying, an repeat the evaporation process with clean water to neutralize the
odor of vinegar. Do not use strong de-calcifiers or sourcing agents nor scratch with
pointed objects. The spout drainage is dishwasher safe.
Should the kettle not be functioning properly or should unexpected malfunctio-
ning occur, we kindly ask you to:
1. First thoroughly read the respective section of the instruction
manual once again.
2. Afterwards please try to find the error with the help of the following mal
function chart.
3. Should you not be able to solve the problem, we kindly ask you to contact
your specialist dealer.
- 13 -
Operation
SAFETY
Cleaning and attendance
ATTENTION
NOTE
GB