Installing The Backrest; Adjusting The Leg Height - Invacare Drop Arm Commode H340 Manual Del Usuario

A
C
1. Align the seat clamps (A) of the toilet seat (B) onto the
back frame rail (C).
2. Push down on the seat until it clamps firmly into place.
3.3

Installing the Backrest

1. Press in and hold the snap buttons (A) on the backrest (B).
2. While holding the snap buttons, insert the backrest into the backrest tubes (C).
3. Push the backrest in until the snap buttons are fully engaged into the holes (D) in the backrest tubes.
There will be an audible click.
3.4

Adjusting the Leg Height

B
A
1. Align the snap button (A) of each leg frame (B) with the appropriate adjustment hole (C) in the leg
extension (D).
2. Make certain that the snap buttons are fully engaged (E) into the adjustment hole of each leg
extension. There will be an audible click.
3. Make sure all leg extensions are at the same height before using.
Drop Arm Commode
B
A
D
D
3.
4.
B
C
C
C
E
4
D
Repeat STEPS 1-2 to install the lid
(D).
Reverse STEPS 1-3 to remove the
lid and seat.
D
Part No 1167461