Overview Of The Components - Clatronic DO 3627 Instrucciones De Servicio

have been given supervision or instruction concerning use of the
appliance in a safe way and if they understand the hazards involved.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. To avoid the exposure to danger, always
have a faulty cable be replaced only by the manufacturer, by our
customer service or by a qualified person and with a cable of the
same type.
CAUTION:
Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning".

Overview of the Components

1 Cutting ledge
2 On/off switch
3 Blade
4 Knife sharpener
5 Cable storage
6 Bottle opener
7 Serrated wheel
8 Lid magnet
Unpacking the appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as foils, padding,
cable ties and cardboard.
NOTE:
There might be dust or production residue present on the ap-
pliance. We recommend cleaning the appliance as described
under "Cleaning".
Instructions for use
Mains cable
Fully unwind the required mains cable. It might be located
inside the cable storage on the back of the appliance.
Electric connection
Check if the mains voltage to be used matches the voltage of
the appliance. Refer to the information on the rating plate.
Operation
The can opener allows you to easily open different kinds of
cans. Round cans are most suitable.
WARNING:
Do not open any cans under pressure!
Can opener
1. Connect the appliance to a properly installed isolated
ground socket.
2. Place the appliance on a flat surface.
3. Flip the cutting ledge open to the top.
WARNING:
The blade is sharp!
4. Slightly tilt the can and position it at serrated wheel level.
5. When opening heavy cans, always hold the appliance with
your other hand.
6. Close the cutting ledge and press the marked position for
the motor to start. The magnet holds the lid of the can.
NOTE:
Hold the can and fully turn it until open.
7. Open the cutting ledge after the lid has been removed.
WARNING:
The lid edges are sharp!
8. Remove the can including the lid from the can opener.
Bottle opener
NOTE:
Always hold the appliance with your other hand.
1. Insert one bottle into the hole on the front of the can
opener.
2. Insert the edge of the crown cap into the holder.
3. Use pressure and push down the bottle in order to open it.
21