Xoro HSD 2220 Manual De Operaciones página 57

Connection
Video Output
Connecting with a S-Video cable
S-Video (S-VHS) cable transmits the signals for brightness (Y-signal) and colour (C-signal)
separately. This connection type offers a better picture quality as CVBS or SCART connec-
tion. Plug a cable into the s-video socket on the rear side of your DVD player. The other side
of the cable must be connected to the s-video input socket of the TV-set (usually labelled "S-
VIDEO IN" or "SVHS IN". Please also refer to your TV set's user manual). As s-video does
not transmit sound, you also must add an audio connection.
Insert one end of the supplied audio (Cinch [RCA]) cable into the white/red Cinch [RCA]
socket L/R AUDIO OUT at the back of the DVD player and the other end into the audio input
socket (usually white/red) on the TV set (usually labelled "AUDIO IN" or "AV IN". Please also
refer to your TV set's user manual). Switch on the TV set and select the s-video input or the
respective channel number. For channel number and input selection please also refer to
your TV operating instructions.
Connecting with a YUV (Y Pb Pr) cable
YUV (Y Pb Pr) is a transmission technology separating colour and brightness information in
the signal. Similar to RGB, the signals are transmitted on a 3 wire cinch [RCA] cable. This
way of transmission is also called "component". This connection offers best picture quality
available with analogue signal transmission. Plug a cable into the Y Pb Pr socket on the rear
side of your DVD player. You can recognize the sockets by their colours red, green and blue
easily. The other side of the cable must be connected to the Y Pb Pr input socket of the TV-
set (usually labelled „Y Pb Pr" or „HDTV IN".
Please change the video output in the Setup settings to "YUV". In case, that your TV set
supports progressive Scan, you can choose by the settings "Scan Mode" the option
"Progressive". Otherwise, you can change the setting during playback from "Interlaced" to
"Progressive" by pressing the P-Scan button on the remote control.
As YUV does not transmit sound, you also must add an audio connection. Insert one end of
the supplied audio (Cinch [RCA]) cable into the white/red Cinch [RCA] socket L/R AUDIO
OUT at the back of the DVD player and the other end into the audio input socket (usually
white/red) on the TV set (usually labelled "AUDIO IN" or "AV IN". Please also refer to your
TV set's user manual). Switch on the TV set and select the YUV input or the respective
channel number. For channel number and input selection please also refer to your TV oper-
ating instructions.
Note:
Make sure you observe the colours of the three sockets when you establish the connection.
When the colours are connected in a wrong way, no picture or a picture with wrong colours
will be displayed.
13