Lenco FMC-282 Instrucciones De Funcionamiento página 5

! ! ! ! ! FM ANTENNA
FM antenna wire for better FM reception.
! ! ! ! ! ADJUSTING THE SOUND
Press the volume +/- buttons to set the sound level. For increased bass at all volume levels, switch
the BASS SWITCH on to boost the low frequency sound. To mute the sound, press MUTE button
on the remote control the POWER ON / MUTE indicator will flash. To resume the sound, press the
MUTE button again or just press the volume +/- button to disable the MUTE function.
! ! ! ! ! RADIO OPERATION
Set the FUNCTION switch to RADIO.
FM
Select FM mode band selector switch. Turn the TUNING control to select the required station. The FM
stereo indicator light will show a stereo broadcast is being received. Fully extend the FM antenna and
adjust its direction for best FM reception.
MW
Select MW on band selector switch. Turn the TUNING control to select the required station. For opera-
tion on MW the set control a built-in ferrite aerial which is directional. Therefore, the set should be
positioned for the best signal strength.
FM STEREO RECEPTION
For reception of a FM stereo broadcast station, set the MW / FM / FM ST. switch to FM ST. position. The
" " will indicate on the LCD display when a FM STEREO broadcast is being received.
! ! ! ! ! LISTENING TO COMPACT DISC (CD)
The LCD indicator always shown the tracks of a disc or program which are still to be played. It works in
all modes, in stop modes, all tracks of the disc or the program are shown.
Playing The Entire Disc
1. Playback will start by pressing PLAY/PAUSE, the "PLAY" indicator then appears.
Playback starts with the first track.The display shown the current track number.
2. To interrupt playback, press PLAY/PAUSE. The "PLAY" indicator will flash.
3. To resume playback, press PLAY/PAUSE again.
4. To stop playback, press STOP.
Selection A Different Track During Play
1. Press SKIP/SEARCH button on the unit (or remote), the required track number appears in the
display.
2. Press PLAY/PAUSE button to starting playing. Starting again with the track that is currently playing.
Starting Again With The Track That Is Currently Playing
1. Press SKIP F.R. once.
2. The track will be started again from the beginning.
Stopping Play
1. Press STOP if you wish to stop play. The disc and track number which can be played will now
appear in the display.
2. Open the CD door on the unit to remove the CD.
GB - 3