Dremel AT01-PGA Instrucciones De Funcionamiento página 8

Fig. 3
6
3
4
8
8
2610046267.indd 8
counterclockwise L). Use the wrench 7 if nec-
essary. The collet nut must be loosely thread-
ed on when inserting an accessory (Fig 2).
4. Insert EZ Lock™ mandrel 6 into collet 4
(Fig. 2).
Make sure the blue spacer
5 on the mandrel bottoms
out on the collet nut, setting the mandrel to
the correct depth. Failure to set the mandrel to
the correct depth can result in damage to the at-
tachment.
5. With the shaft lock 2 engaged, tighten the
collet nut 3 securely (turn clockwise T) with
wrench 7 (Fig. 2).
Note: If the EZ Lock™ mandrel does not fit into the
collet, it is possible that the collet is stuck within
the collet nut. If this happens, remove the collet
nut from the tool by continuing to twist it coun-
Assembly
terclockwise. If the collet does not separate from
the collet nut when removed from the tool, push
the shank of the EZ Lock™ mandrel 6 into the hole
in the collet nut 3. This should cause the collet
4 to pop out of the collet nut 3. Re-assemble by
placing the collet 4 into the output shaft 8 and
twisting the collet nut 3 clockwise over the collet
to tighten it back onto the output shaft 8 (Fig. 3).
Then proceed with installing the EZ Lock™ man-
drel according to the instructions.
To load sanding disc:
1. Pull spring-loaded sleeve 9 DOWN towards
tool with one hand and hold. You can brace the
tool on the body or workbench for extra lever-
age (Fig. 4).
2. With the other hand, align bow tie interface 10
on mandrel with metal bow tie interface 11 on
bottom of sanding disc 12 (Fig. 4).
3/2/17 1:00 PM