rtd CORECEM Instrucciones De Uso página 3

•
Store used CORECEM
•
Do not pull back on the plunger after dispensing. This may cause plugging of the syringe.
Working time in the self-cured mode (23°C (74°F)): 1:30 minutes from start of mixing.
Setting time in the self-cured mode (23°C (74°F)): 5:30 minutes from start of mixing.
-syringe with fixed used mixing cannula in the dark.
®
POST CEMENTATION
•
Prepare the post space according to manufacturer's
instructions. Etching and Primer are required.
•
Dispense a small amount 2-3mm to eliminate the pre-
vious mixing and voids.
•
Apply CORECEM
canal tip (recommended). Filling should occur from
bottom upward to prevent voids.
•
Seat the post, light-cure for at least 20s. (400mW/cm²)
CORE BUILD-UP
•
Fill in CORECEM
fill in directly into the preparation. Filling should occur
from bottom upward to prevent voids
•
Light-cure for at least 40s 400mw/cm² or allow the sys-
tem to self-cure for at least 3 minutes
•
Remove the matrix when the material is completely
set.
•
Start the final crown preparation.
• CORECEM
For
during trimming. After finishing, blue color will become
dentin shade like A1.
inside the root canal using the root
®
into the COREFORM
®
ILLUSION
® use cold water spray
matrix or
™