Elettro LEM61211 Instrucciones De Uso página 8

The quick-fit connector of the conductors with eyelet terminals is fitted with an insulating protective cap
to be always replaced on the quick-fit connector once charging has been completed.
SPECIFICATIONS
The charging properties of this device permit to charge the battery to 100% of its capacity and make it
possible long time connections of the battery to the charger when not in use to maintain the battery in
good conditions without damaging it.
Different charging modes are available.
It is available a special function for rescuing deeply discharged batteries.
Full protection against wrong connections, polarity reversals and short circuits assure safe charging
operations.
The built-in electronic switch prevents the charger from starting immediately when connected to the
battery but only after the user will select a charging mode.
The control and fulfilment of the charge cycle is managed by a microprocessor.
INCLUDING AS STANDARD:
Connecting clamps to the battery.
Eyelet type terminals for motorbike connection.
MAINTENANCE
When the battery charger is not in use, it must be stored in a dry place.
To clean the outer case, disconnect the appliance and use a moister cloth. Do not use running water or
detergents.
The battery charger shall be repaired or serviced exclusively by qualified personnel.
8