Fan Electric Controller - 0020800 - A; Remote Control Operation - La Nordica FOCOLARE 60 Manual De Instrucciones

FAN ELECTRIC CONTROLLER - 0020800 - A

The fan electric controller allows for the simple and intuitive selection of the speed of the convection air dissipated into the environment of
our solid combustion wood product. The controller must be placed away from nozzles or from the main heat source; if placed in the counter
hood, it must be positioned in a low heat point. Simple installation is guaranteed by the the fact that it can be fitted in classic recessed
electrical boxes commonly found in buildings, or it can be wall-mounted.
The controller activates ventilation in MANUAL/AUTOMATIC/COMFORT mode, which can be selected on the controller display by pressing/
touching the keys.
Control OPERATION.
This electronic controller for packaged units manages ventilation air flows. The
controller is switched on or off by pressing and holding the 1 button. During
operation the display shows the set speed alternating with unit status, led 9.
When the unit is off, the display also remains off.
The unit can be controlled MANUALLY or AUTOMATICALLY.
MANUAL mode.
To access MANUAL mode, press the 2 button; when the 3 light comes on the
function is active. The 4-5 buttons are used to select one of the five fan speeds, also
active when the flue is cold.
The motor is started in automatic mode by a mechanical thermostat (the display
shows WAIT), which is activated when the temperature is at least 45°C (fixed value,
not modifiable). The 6 led indicates that the thermostat contact is closed.
AUTOMATIC mode.
To access AUTOMATIC mode, press the 2 button; when the 7 light comes on the function is active. Use the 5 button to set the speed.
The 4-5 buttons are used to select one of the five fan speeds.
In automatic mode the COMFORT temperature can also be selected.
Press the 4 button to access the COMFORT temperature setting and then set the value using 4-5. This setting allows the user to reduce
fan noise when the room temperature measured by the probe inside the controller exceeds the comfort set point; the motor operates one
speed lower (this mode has no effect in first speed) and is signalled by the 8 led.
LANGUAGE menu.
Pressing and holding the 2 button accesses the LANGUAGE menu, where the display language can be changed using the 4-5 buttons (IT,
EN, DE, FR). Pressing the 2 button briefly again accesses the DISPLAY menu, where the brightness can be adjusted (between 10 and 150).
Pressing the 2 button briefly another time accesses the DEGREES menu, where the temperature display can be set as °C or °F.
BUZZER menu
Pressing the 2 button briefly a final time accesses the buzzer menu, where audible buzzer can be enabled or disabled.

REMOTE CONTROL OPERATION:

The electronic controller for fan can be managed by an IR remote control.
The controller is switched on or off by pressing and holding the 11-12 buttons.
To switch from MANUAL to AUTOMATIC on the IR remote control press the 13-14 buttons. The LED corresponding
to the operating mode comes on, manual 3 or automatic 7.
In MANUAL mode only the buttons in the 11-13 group are enabled for selecting one of the five speeds.
In AUTOMATIC mode, the buttons in the 12-14 group are enabled for selecting one of the five speeds, as well as
the buttons in the 11-13 group for changing the COMFORT set point.
The 10 LED comes on whenever a button is pressed on the remote control; if this does not happen, check the
batteries.
12
5
6
7 7
8
ENGLISH
3 7 9 8
A
2 4 5
A
1 2 3 4
O1
10
11
13
6
OK
1
12
14