HAEGER Bullet Plus Instrucciones De Uso página 5

Instructions for use
1. Take the device out of the box and remove the inner and outer packing.
2. Make sure that the motor filter is correctly installed (see paragraph "How to empty the
container and clean the filter").
3. Make sure the ON/OFF switch is in OFF position (turned off).
4. Insert the plug of transformer into the power outlet.
5. Place the device for recharging (see paragraph "Recharge of the device").
Note: For the first time you should recharge the device for at least 14 consecutive hours.
Using the device for dry suction
1. Remove the device from its recharge holder.
2. Use the extension attachment as final accessory; apply pressure on it to attach it.
3. The brush attachment cannot be directly attached to the appliance; it must be attached to
the extension attachment only when you intend to use it.
4. The appliance can suck up crumbs even without the terminal attachment.
5. Turn on the device moving the switch forward.
6. While operating the device, always keep the suction nozzle turned downwards.
7. To turn off the device, operate again on the switch moving it backwards.
Note: Empty the container and clean the filter when:
– The suction power decreases.
– Crumbs come out from the suction nozzle.
– Each time after use, before replacing the device in its recharge seat.
Using the appliance to suck up liquids
1. Use the liquid suction attachment as final attachment; apply pressure to it to attach it.
2. Push the switch forward to switch the appliance on.
3. Keep the appliance on with the suction inlet facing down at all time.
4. Pull the switch back to switch the appliance off.
Note: Empty the container immediately after use and wash the filter. Rinse the container and
the filter in cold water and let all parts dry completely before reassembling them.
Recharging the device
1. Insert the plug of transformer into the power outlet.
2. Make Sure the on/off switch is in OFF position (turned off).
3. Please recharge the appliance. When the appliance will be correctly positioned then the
LED will display a red light. Note: when you are not using the device, keep it always placed
in its recharger holder.
4. After 5 minutes of continuous use, the suction power may decrease.
5. Place the device in its seat and let it recharge for at least 2 hours.
Instructions for use
English
3