Delta 22-555 Manual De Instrucciones página 5

ADDITIONAL SPECIFIC SAFETY RULES
12. Never reach into the cutterhead area while the
machine is running. Your hands can be drawn into the
knives.
13. Do not stand in line of the workpiece. Kickback can
cause injury.
14. Allow the cutterhead to reach full speed before
feeding a workpiece.
15. When planing bowed stock, place the concave (cup
down) side of the stock on the table and cut with the
grain to prevent kickback.
16. Do not feed a workpiece that is warped, contains
knots, or is embedded with foreign objects (nails,
staples, etc.). Kickback can occur.
17. Do not feed a short, thin, or narrow workpiece into
the machine. Your hands can be drawn into the
knives and/or the workpiece can be thrown at high
speeds. See the "operation" section of this instruction
manual for details.
18. Do not feed a workpiece into the outfeed end of the
machine. The workpiece will be thrown out of the
opposite side at high speeds.
19. Remove shavings only with the power "off" to prevent
serious injury.
SAVE THESE INSTRUCTIONS.
Refer to them often and use them to instruct others.
20. Properly support long or wide workpieces. Loss of
control of the workpiece can cause serious injury.
21. Never perform layout, assembly or set-up work on
the table/work area when the machine is running.
Serious injury will result.
22. Turn the machine "off", disconnect it from the power
source, and clean the table/work area before leaving
the machine. Lock the switch in the "off" position
to prevent unauthorized use. Someone else might
accidentally start the machine and cause injury to
themselves or others..
23. Additional information regarding the safe and
proper operation of power tools (i.E. A safety video)
is available from the power tool institute, 1300
sumner avenue, cleveland, oh 44115-2851 (www.
Powertoolinstitute.Com). Information is also available
from the national safety council, 1121 spring lake
drive, itasca, il 60143-3201. Please refer to the
american national standards institute ansi 01.1 Safety
requirements for woodworking machines and the u.S.
Department of labor osha 1910.213 Regulations.
5