Troubleshooting
Problem
The DVD regional codes
can no longer be
changed.
The Wireless LAN/
Bluetooth modules
cannot be detected.
The PC Camera module
cannot be detected.
The Wireless LAN/
Bluetooth/ PC Camera
modules cannot be
configured.
The code has been changed the maximum 5 times. DVD region detection is device dependent,
not OS-dependent. You can select your module's region code 5 times. The fifth selection is
permanent. This cannot be altered even if you change your operating system or you use the
module in another computer.
The modules are off. Check the LED indicator
WLAN/Bluetooth module is on or off (see
off, then press the Fn + F11 (WLAN) or Fn + F12 (Bluetooth) key combination(s) in order to
enable the modules (see
Table 4, on page
The module is off. Press the Fn + F10 key combination in order to enable the module (see
Table 4, on page
12). Run the BisonCap program to view the camera picture.
The driver(s) for the module(s) have not been installed. Make sure you have installed the driver
for the appropriate module (see the instructions for the appropriate module in
Installation Procedure" on page
Possible Cause - Solution
and/or function key indicator to see if the
"LED Indicators" on page
12).
26).
Concise User's Guide
10). If the LED indicator is
"Driver
Troubleshooting - 31