Operation; Cleaning And Maintenance; Cleaning The Heating Element - EuroLite NH-30 Hazer Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!

OPERATION

Switch the device on via the power switch. Connect the remote control with the remote control-socket.
After a certain warm-up time, the device is ready to operate. Then the stand-by lamp, green LED, of the
remote control lights up. By operating the haze switch on the remote control the haze emission starts. It may
happen that the stand-by lamp turns off and the haze emission stops. In this case the device is heating up
again, red LED, and will be ready to operate in approx. 1-2 min. This process guarantees an appropriate
vaporization temperature and the best haze emission possible. The temperature is regulated by a high
quality thermostat.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
Clean the escape nozzle frequently from haze fluid residues.

Cleaning the heating element

The heating element should regularly be cleaned every 30 operational hours in order to avoid clogging. Use
haze machine cleaner available at your dealer.
Procedure:
Fill cleaner into empty tank. Run the machine several times in a well-ventilated room only. The number of
repititions depends on the pollution level of the vaporizing elements. After use clean all remaining cleaner
and rinse the tank thoroughly.
International
L
N
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
To engage the timer function depress the yellow
button on the handheld unit and adjust the INTERVAL
knob. The INTERVAL knob regulates the length of
time of the haze blast. The blast can be set for
between 10 and 200 seconds. The VOLUME knob
controls the amount of haze. This can be set between
0% and 100%. For continuous hazing, depress the
red button marked CONTINUOUS. This will set the
unit to haze steadily at the selected volume. The
green MANUAL button overrides all the buttons but
not the knobs to deliver a full volume blast of haze for
as long as the button is held down.
14/27
51701985X03NXS_V_1_1.DOC

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

51701985

Tabla de contenido