BOJ KT-1700X Manual De Uso página 6

English
lit and the appliance beeps twice which means that the base is connected to the power source
and the kettle is placed on the base.
4. Close the lid and place the kettle on the power base (5), the appliance beeps once, the display
turns on and the Start/Cancel button stars to heat. you will see the current water temperature
which will be visible on LED. If you do not perform any actions, the kettle turns off automatically.
5. Press the Start/Cancel button (10) without setting other functions. The kettle turns on and
beeps, the Start/Cancel button will be lit red. The kettle boils water up to 100°C, then switches
off auto-matically and beeps three times.
6. If you just want to heat up the water, use the boiling temperature buttons „up" or „down". Press
once to change the temperature. The temperature setting will be shown on the display. You may
select between the pre-defined temperature settings: from 40°C up to 100°C each 5°C. If the
temperature set is lower than the temperature of water in the kettle, the kettle switches off.
7. After reaching the desired temperature of water, the kettle switches off and beeps three times.
8. If you want to select the keep-warm function, press the button (7) , the keep-warm light will
be lighted under the button. In this mode press the button „up" or „down" to set the desired
temperature. The temperature adjustment (increase and decrease) step is 5°C. The available
range of temperature setting 40–100°C. In order to switch off the keep-warm function, press the
keep-warm button (7) again or Start/Cancel button (10) to switch off the kettle. Otherwise the
water temperature will be maintained at a pre-set level. If no action is taken for 2 hours in the
keep-warm mode, the kettle will switch off. Press the Start/Cancel button (5) again to turn on
the kettle (the kettle beeps once).
NOTE! The kettle may be used only with the based attached. Do not open the lid when boiling
water.
OPTIMUM TEMPERATURE FOR TEA AND COFFEE
40-60°C – blends for babies
70°C – green and white tea
90°C – instant coffee
100°C – black tea
CLEANING
Before your cleaning, please unplug the electrical kettle and make sure it has been cooled down.
Never immerse any part of the cable, plug, power cord base or kettle in water or any other liquid.
Exterior of the kettle
Wipe the exterior of the kettle with a piece of damp cloth and then dry it with a piece of dry cloth.
Never use harsh chemicals or abrasive cleaning agents as these may damage the finish of your
kettle.
Interior of the kettle
Over using a period of time, lime scale would be built up inside of your kettle.
To remove lime scale:
1. Half fill the kettle with water and add the juice of a lemon.
- 6 -