Universal Remote Control F20 Manual De Usuario página 14

25
STEP 7:
Press the LIGHT button after you enter the
channel number.
A new screen appears displaying SAVE,
UNDO or EXIT.
STEP 8:
To save the channel you entered, press
the SAVE display button. The UNDO
display button lets you erase the last
entry. The EXIT display button erases all
entries for this button.
STEP 9:
When you are finished setting up Favorite
Channel buttons, press the MAIN button
twice to return to normal operation.
SAVE
BUTTON
MacroPower™ Setup
MacroPower™ is a unique feature that enables you to turn all of your Components
ON or OFF, at the same time, simply with the press of one button.
We call that a "Macro". What would normally take multiple remotes and button
pushes, the RF20 can accomplish with the press of one button. In addition to the
Power ON or OFF buttons, any of the Display buttons (on any Component or Page)
can be set to be Macro buttons as well. Feel the power!
To setup a Power ON macro button that will turn ON several components at the
same time (for example, TV, VCR and CABLE), follow these easy steps:
STEP 1:
Press and hold the MAIN and ENT (Enter)
buttons at the same time for approximately
3 seconds, until the word "SETUP" is
displayed at the top of the LCD touch screen.
This signals that you are now in setup mode.
IMPORTANT: You now have 30 seconds to per-
form the next step while you are in SETUP
mode. If you don't press a button within 30 sec-
onds, SETUP will disappear from the screen,
signaling that you have exited setup mode and
you will need to start over.
STEP 2:
Press the MACRO display button on the LCD
screen. The top of the screen will display
"MACRO". The bottom of the display will
flash "SELECT".
STEP 3:
Press the ON button. "ON" will display at the
top of the LCD screen. "STEP0" will display at
the bottom of the screen indicating that no
macro steps have been entered yet.
STEP 4:
Press the first component display button you
want the Macro to turn on (in this example,
TV) and "TV" will display at the top of the
screen and "STEP 1" at the bottom.
STEP 5:
Then, press the ON button to confirm the
command and "STEP 2" will display at the
bottom of the screen. (NOTE: Whenever a
button is pressed, another Macro step is
counted and dis-played at the bottom of the
screen.)
STEP 6:
Now, press the MAIN button to return to the
Main Component listing. ("STEP 3" will display
at the bottom of the screen.)
26