General Operation; Operating Temperature - Oregon ST250 Manual De Instrucciones Originales

OREGON® CORDLESS TOOL SYSTEM
TRIMMER/EDGER MODEL ST250

GENERAL OPERATION

WARNING: ALWAYS WEAR PROPER
EYE PROTECTION, LONG PANTS, AND
FOOT PROTECTION.
IMPORTANT: USE CARE AROUND
STRUCTURES, TREES, AND BUSHES TO
AVOID DAMAGING PAINT OR BARK.

OPERATING TEMPERATURE

This trimmer/edger is designed to
operate within a temperature range of
0°C to 40°C (32°F to 104°F)
IMPORTANT: THE TRIMMER/
EDGER IS EQUIPPED WITH A
TEMPERATURE SENSOR THAT
STOPS THE MOTOR TO PREVENT
THERMAL OVERLOAD DAMAGE.
IF THE TRIMMER/EDGER STOPS
WORKING SUDDENLY, IT MIGHT BE
TOO HOT TO CONTINUE RUNNING.
ALLOW THE TOOL TO COOL BEFORE
CONTINUED OPERATION. SEE
"TROUBLESHOOTING" FOR MORE
INFORMATION.
GRIP
The front handle on the trimmer/
edger handle is adjustable to suit the
height and reach of the operator and
application You can move the handle
forward or backward along the shaft
until it is in a comfortable position for
trimming, clearing, or edging
AE 0213 - F/N 558938
OPERATING THE TRIMMER/EDGER
Loosen the clamping screw until the
front handle slides along the shaft, move
the handle to a comfortable position,
and then tighten the clamping screw
(Fig 12)
FIG. 12
When using the trimmer/edger, grip both
the front and rear handles firmly
FOOTING
Stand or walk with both feet on solid
ground Do not overreach
STOPPING THE TRIMMER/EDGER
Release the throttle trigger to stop the
trimmer/edger
STARTING THE TRIMMER/EDGER
Grasp the front and rear handles firmly
Squeeze the trigger lock-out (1), then
squeeze the throttle trigger (2) until the
trimmer head moves at the desired
speed (Fig 13)
FIG. 13
(1) TRIGGER LOCK-OUT
(2) THROTTLE TRIGGER
19