EIBENSTOCK ESM 1310 Instrucciones De Servicio página 18

Attention!
High-energy and high-frequency interference can cause
!
fluctuations in speed. In case of low speed adjustments, the
machine can be overloaded easier.
Even if the electronics is not interrupted, there is the danger
of overload. Therefore, work with soft pressure in order to
avoid an excessive heating of the motor due to a too high
power input.
Hand Guard
Attention!
Before the beginning of all works disconnect the plug from
the mains!
Insert a Finishing Wheel
Remove the knurled
head screw.
Attention!
For mounting the Rubber air roller remove one of the keys.
Let the machine run for a short period of time and in a safe position. If the
machine does not run easily, stop working immediately.
Switch the machine on and put it carefully on the surface you want to work
on. Hold the tool with both hands and work with circular or linear
Only run the Calender with the mounted hand
guard. After opening the Allen screw M5 can
again be turned in a position which is ideal for
the application (always between machine and
user).
Afterwards, retighten the Allen screw.
Retooling
Put the wheel in a way on the connection
shaft that it can be recepted by the two keys
of the shaft. Secure the finishing wheel by
means of the knurled head screw.
18