Polygroup SUMMER WAVES SKIMMERPLUS SFX600 Manual Del Usuario página 15

STEP 3: Pump Reassembly/Replacement
1. Lubricate the Canister Gasket 4
groove for SFX600/SFX1000) at the bottom of the Skimmer Canister
9
2a. If your Pump is removed from the pool, slowly insert the Motor Assembly
back into the upside-down Canister. There's an indent on the inside of
Canister (only visible from bottom), which needs to be aligned with an
indent at the bottom of the Motor (marked "ALIGN"); to this end, make
sure that the arrow of the "ALIGN" mark is pointing to the Canister indent.
Close Up
BOTTOM VIEW OF PUMP & CANISTER
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
, then insert it back into the groove (inner
4
Extended operating days and hours during peak season requirements.
IMPORTANT: make sure that the cord of the
9 .
Motor Assembly
Seal Nut 1 BEFORE replacing the Pump.
2b. If your Pump is left attached to the pool, reach in through the Canister to
pull the Motor Assembly up and insert it back into the Canister. Make sure
that the key of the Canister is slotted into the notch on the Pump to align
the Rubber Nozzle
the Pump may leak even already locked in place.
TOP VIEW
Outlet of Canister and Rubber Nozzle 2
on the pump should be aligned.
OWNER'S MANUAL
3 is placed through the Motor
4
3
2
1
2 with the hose opening of the Canister, otherwise
Make sure that the key of the Canister
is slotted into the notch on the Pump
15