Waterway POWER DEFENDER 1.65 HP Manual Del Propietário página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WIRING
WARNING: RISK OF ELECTRICAL SHOCK OR ELECTROCUTION.
certified electrician or a qualified pool serviceman in accordance with the National Electrical Code and all applicable
local codes and ordinances. Improper installation will create an electrical hazard which could result in death or damage
to property. Always disconnect power to the pool pump at the circuit breaker before servicing the pump. Failure to do
so could result in death or serious injury to serviceman, pool users or others due to electric shock.
1. Make sure all electrical breakers and switches are turned off
before wiring motor.
2. Make sure that the wiring voltage matches the motor
voltage (230v or 115v). If they do not match the motor will
burn up.
3. Choose a wire size from Chart 1. When in doubt use a
heavier gauge (larger diameter) wire. Heavier gauge will
allow the motor to run cooler and more efficient.
4. Cut wires to the appropriate length so they don't overlap or
touch when connected to the terminal board.
5. Make sure all electrical connections are clean and tight.
6. Permanently ground the motor using the correct wire size
and type specified by National Electrical Code. Make sure
the ground wire is connected to an electrical service ground.
7. Bond the motor to the pool structure in accordance with the
National Electrical Code. Use a solid No. 8 AWG or larger
copper conductor. Run a wire from the brass external
bonding clamp to the pool bonding structure.
8. Connect the pump permanently to a circuit. Make sure no
other lights or appliances are on the same circuit.
NOTE: If the pump is installed below the water level of the pool, close return and suction lines prior to opening
hair and lint pot on pump. Make sure to re-open valves prior to operating.
This pool pump must be installed by a licensed or
SUPPLY WIRE SIZES (AWG)
Size and Length by Horsepower
HP
115 Volts
50 Ft.
100 Ft. 150 Ft.
1/3
14
14
1/2
14
12
3/4
12
12
1
12
10
1 1/2
10
10
2
10
8
3
2
230 Volts
50 Ft.
100 Ft. 150 Ft.
12
14
14
10
14
14
10
14
14
8
14
14
8
14
14
8
14
12
12
12
CHART 1
14
14
14
14
12
12
12

Publicidad

Tabla de contenido
loading

Productos relacionados para Waterway POWER DEFENDER 1.65 HP

Este manual también es adecuado para:

Power defender 300

Tabla de contenido