Vox AC15 Custom Classic Serie Manual De Usuario página 5

8 Ohm:
Model AC15CC1X
3. Footswitch jack:
4. HT Fuse:
5. Mains Input:
6. Mains Fuse:
Power Output:
Internal speaker:
Valve/tube complement: 2 x EL84/6BQ5 & 2 x 12AX7/ECC83.
Rectifier:
Mains input:
Mains Fuse value:
HT Fuse:
Dimensions:
Weight:
Included items:
Appearance and specifications of this product are subject to change without notice.
URL = http://www.voxamps.co.uk
Allows for the following configurations:
1) Set it to this if you connect an extension cabinet. You'll be running the
internal and external speaker in parallel. The impedance of the extension
cabinet must be 16 Ohms.
2) Set it to this if you connect an external 8 ohm cabinet and disconnect
the internal speaker.
This has an 8ohm loudspeaker internally fitted and the amplifier must be
set at 8ohm output. This speaker must be disconnected if amplifier is used
with an extension cabinet.
This is where you connect the supplied VF002 VOX footswitch so you can
turn the Reverb and Tremolo on and off.
This fuse protects your amp should a fault occur with the power. The most
common reason for this fuse to blow is when an output tube becomes
faulty. The correct value of the HT fuse is located on the rear panel of the
amplifier and should only be replaced with one of the same value.
This is where the supplied, detachable Mains (power) cord is connected.
The specific mains input voltage rating that your amplifier needs to run at
is located on the rear panel of your amplifier. Before making any connec-
tions or powering up the amplifier, make sure the correct voltage is set. If
you have any doubt, refer to your local VOX dealer.
This fuse provides an overall safety protection in the event your amplifier
develops and electrical fault. The correct value of the fuse is located on the
rear panel of your amplifier and should only be replaced with one of the
same value.
Specifications
15 Watts RMS into an 8 or 16 ohm loudspeaker load.
16 ohm, 12", 30 Watt VOX/Wharfedale Custom—model AC15CC1
8 ohm 12", 15 Watt VOX/Celestion AlniCo Blue—model AC15CC1X
silicon rectifier with passive SAG circuit.
preset 100V or 120V or 230V or 240 V ~ 50 or 60 Hz depending on country
of sale. Please see Rating Plate on rear of amplifier for exact specification.
250V, T1.6AL for 100V / 250V, T1.25AL for 120V
250V, T630mAL for either 230V & 240V.
Warning!—Replace fuse with same type and rating
250V, T250mAL.
605 x 262 x 440 mm / 23.82" x 10.31" x 17.32"
AC15CC1: 21.6kg / 47.62 lbs. , AC15CC1X: 21.7kg / 47.84 lbs.
Power cable, VF002 footswitch
5