Controls And Safety Instructions For Assembly - Narex ESN 400 Long Run Manual De Uso Original

Controls and Safety Instructions
for Assembly
Brake lever
LCD screen
Error
message
Charge
status
LCD Screen
Instructions to Buttons and Functions
1. Power switch
Holding down on the button turns power on/off.
2. Gas
Pressing the gas button accelerates the scooter.
3. Brake
Holding the brake stops the scooter. Slightly pressing onto
the rear mudguard with your foot helps in braking.
4. The function button switches between three modes:
Beginner mode: no letter appears in the gear field
Standard mode: letter D appears in a white field
Sports mode: letter D appears in a red field
5. Lights
The lights are turned on by pressing the function button
for a short time twice. Turn off the lights in the same way.
6. Cruise control
Cruise control maintains the chosen speed. To activate
cruise control, maintain constant speed for 6 seconds.
Cruise control switches off once you press on the gas or
brake.
7. If the error message indicator lights up, contact
your retailer to arrange servicing.
65405597A__E-Scooter_ESN-400.indb 31
8. Setting functions
To enter the function set-up menu, press and hold the
function and power switch button simultaneously for
5 seconds.
1. Select the function you wish to adjust (P0/P1/P2) using
Function button
the function button.
2. Press the power switch button to access the function.
3. Select the function setting (0 or 1) using the function
button.
Power switch
4. Confirm with the power switch button
Gas button
The following functions can be set:
P0 – setting unit of speed
0 – km/h
Speed
1 – miles
Gear
P1 – cruise control setting
Unit of speed
0 – off
1 – on
P2 – setting gas response
0 – immediate acceleration
1 – acceleration after reaching speed of at least 4 km/h
P3 – wheel size setting
0–8,5"
1–10"
P4 – max speed setting
20 km/h, 25 km/h, FF – unlimited speed
English
31
07.08.2020 10:14:30