Festool CTL 48 E LE EC/B22 R1 Manual De Instrucciones página 16

CT B22
GB
WARNING!
– Machine may contain hazardous dust. Only authorised qualified spe-
cialists with suitable protective equipment may perform maintenance, empty the
container and change the filter.
– Always operate with the filter system installed!
When extracting large quantities of oak or beech wood dust or dust that exceeds
the permitted limit values, only extract from a single machine (electric or air
tool).
– Risk of explosion and fire hazard: Also observe any other restrictions relating to
dust with an ignition energy of less than 1 mJ specified by the labour authorities. Do
not extract sparks or hot dust, flammable or explosive fluids (e.g. petrol, thinner),
aggressive fluids/solids (e.g. acid, leach, solvent). This mobile dust extractor is suit-
able for extracting paint dust.
– Do not damage the mains power cable (e.g. by driving over, dragging, etc.). Protect
from heat, oil and sharp edges. Do not pull the plug from the socket by the cable.
– Check the plug and the cable regularly and have them replaced by an authorised
service workshop should either become damaged. Always replace the mains power
cable with the type specified in the spare parts list.
– Do not expose the machine to rain.
– For reasons of safety, never operate the machine from an unearthed socket.
– Always use the machine socket for the purpose specified in the manual.
– Always use original Festool accessories.
– Pull the plug from the socket when the machine is not in use and prior to mainte-
nance and cleaning work.
– Attention! To avoid electrostatic charging do not clean the device with a dry cloth.
Use an antistatic cloth or damp cloth.
– Design 22 dust extractors are suitable for connecting to machines in Zone 22. Care
must be taken to ensure that no sources of ignition are extracted. Conductive ma-
chine components, including extractor hoods, and conductive parts on machines
from protection class II must be electrostatically earthed. The electrostatic earthing
can be routed through the dust extractor or established using separate electrostatic
earthing equipment.
–Risk of explosion: Keep the socket on the appliance closed in zone 22 at
all times and do not use it there.
– Incorporate the device in your explosion prevention or fire prevention documenta-
tion.
– In the event of a fire immediately disconnect the machine from the power supply and
16