Audible Beep Settings; Flash Output - Starblitz SHARK200 Manual De Usuario

The following picture shows how to set the same groups between flash light and
EN
remote controller.
FR
ES
Press the slave button 8 seconds, or wait 20 seconds to quit to output power page.

Audible Beep Settings

Push the Beeper Button
to fire, to provide an audible "Ready confirmation".
 Turning the switch
matically while the flash is fired.

Flash Output

- The flash power output is variable over a 5 f-stops range (6 f-stop points) from full
to 1/32 in 1/10 f-stop increments using two power regulator adjustment buttons
(Fig.1) on the rear panel.
10
Group number on
SHARK Studio Flash
G.A
G.B
G.C
G.d
(Fig.1) to 'ON' to give a short beep when the unit is ready
5
(Fig.1) OFF will allow the modelling lamp to turn off auto-
5
Corresponding group
on remote controller EX-801C
Group 1
Group 2
Group 3
Group 4
1