Hahnel Giga T Pro II Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
To set parameters for Basic
Programme
14
Long:
A: For Single Shot Set to
00 00 00 values
B: For Continuous
Shooting
Sets the length of the
contiuous shooting burst.
C: Bulb Exposure - Sets
the length of time the
shutter is open
15
Interval 1:
Time interval between
shooting or, if in continuous
shooting mode, between
bursts of shooting.
Must be set higher than camera shutter
speed
16
N1:
A: For Single Shot Sets
the Number of shot taken
B: For Continuous
Shooting
Number of bursts of
Continuous Shooting.
C: Bulb Exposure -
Number of shots taken
To set parameters for Repeating of
Programme
17
Interval2:
Time interval between
each repeat of "Basic
Programme"
18
N2:
Number of times the above
"Basic Programme" is
repeated.
The programme is now set. Press
(play/stop) to activate or stop the
programme.
Note:
Double green flash on receiver
indicates an interval timer programme is
in operation.
To Run Basic Programme one time
only
Set parameters for Basic Programme as
normal. Ignore Interval 2 setting and set
N2 = 1
See www.hahnel.ie for examples
FAQ's
To turn off the autofocus in between shots
of sequential shooting or the Basic Timer
Function, ensure Autofocus is disabled on
your camera.
A number of channels are available on
your remote control to allow you to use
several receivers, each set to a different
channel, activated by one single
transmitter. Simply change the channel on
the transmitter as desired to activate each
seperate receiver.
To calculate the number of shots taken,
multiply N1 x N2.
If using bursts of continuous shooting, to
calculate the number of shots taken,
multiply 'frames per second' setting of the
camera x Long x N1 x N2.
Caution
Do not modify product
Keep receiver and transmitter dry at
all times
Do not use in the presence of
flamable gas
Keep out of the reach of children
Do not expose to excessive
temperatures or strong direct sunlight
Do not leave the unit in the trunk or
on the dashboard of a vehicle.
Overheating can result in leaking, fire
or explosion
Observe correct polarity
Dispose in accordance with
appropriate environmental regulations
Take battery out of unit if stored for
an extended period of time.
R&TTE Directive Declaration
Hähnel Industries hereby declares that the
Giga T Pro II is in compliance with the
essential requirements and other relevant
provisions of the R&TTE Directive
1999/5/EC. A copy of the Declaration of
Conformity can be viewed at
www.hahnle.ie

Publicidad

Tabla de contenido
loading

Productos relacionados para Hahnel Giga T Pro II

Tabla de contenido