Publicidad
OUTPUT CONNECTIONS
Multiple 25 V speakers
Unplug the power supply and remove the output terminal security cover. Connect constant voltage speakers to a single output voltage tap. Do not connect speakers with dissimilar voltages to multiple
output taps. Total connected load must not exceed 35 W. Upon completion of the output terminal block wiring, re-install the cover over the terminal block prior to plugging in the power supply.
OPERATION
SIGNAL PRESENT
RDL•
659 6th Street
•
Prescott, AZ
•
891-3415A
Copyright © 2011 Radio Design Labs, Inc. RDL, Radio Design Labs and the RDL logo are registered trademarks of Radio Design Labs, Inc. Data reflects product at publication time, subject to change without notice. "Made in USA" applies to all HD products except power supplies. Other trademarks, if any, are the property of their respective owners.
INPUT LEVEL
Adjust level control for the desired output level with the remote control (if used) set to normal operating position.
The green LED glows when audio is present at the input. The indication is not affected by the setting of the mixer level control.
USA 86301
•
Sales: 800-281-2683
•
928-443-9391
Multiple 70 V speakers
TONE CONTROLS
Adjust BASS and TREBLE as desired.
COMPRESSION INDICATOR
LED flashes when audio compressor is
acting on the amplified audio.
•
Tech Support: 800-933-1780
•
928-778-3554
Multiple 100 V speakers
POWER INDICATOR
Glows dimly when unit is in standby (off)
mode; glows bright when amplifier is on.
POWER BUTTON
Latching pushbutton switches the
amplifier ON or off (STANDBY).
•
RDL Europe Sales & Support: (31) 20-6238-983
•
www.rdlnet.com
Publicidad
