Tabla de contenido
Publicidad
3) Keep bystanders, children,
and visitors away while
operating the tool. Distractions
are able to result in the loss of
control of the tool.
PERSONAL SAFETY
1) Stay alert. Watch what you
are doing and use common
sense when operating the tool.
Do not use the tool while tired
or under the influence of
drugs, alcohol, or medication.
A moment of inattention while
operating the tool increases the
risk of injury to persons.
2) Dress properly. Do not wear
loose clothing or jewelry.
Contain long hair. Keep hair,
clothing, and gloves away
from moving parts. Loose
clothes, jewelry, or long hair
increases the risk of injury to
persons as a result of being
caught in moving parts.
3) Avoid unintentional
starting. Be sure the switch is
off before connecting to the
air supply. Do not carry the tool
with your finger on the switch or
connect the tool to the air supply
with the switch on.
4) Remove adjusting keys and
wrenches before turning the
tool on. A wrench or a key
that is left attached to a rotating
part of the tool increases the risk
of personal injury. Note: Only
applies to a tool with a
rotating output.
5) Do not overreach. Keep
proper footing and balance at
all times. Proper footing and
balance enables better control of
the tool in unexpected situations.
6) Use safety equipment. A
dust mask, non-skid safety
shoes and a hard hat must be
used for the applicable
conditions.
7) Always wear eye protection.
8) Always wear hearing
protection when using the
tool. Prolonged exposure to high
intensity noise is able to cause
hearing loss.
9) Do not attach the hose or
tool to your body. Attach the
hose to the structure to reduce
the risk of loss of balance if
the hose shifts.
10) Always assume that the
tool contains fasteners. Do not
point the tool toward yourself
or anyone whether it contains
fasteners or not.
11) WARNING – Do not nail on
top of another nail. This is
able to cause the nail to be
deflected and hit someone, or
cause the tool to react and
result in a risk of injury to
persons.
12) WARNING – Remove finger
from the trigger when not
driving fasteners. Never carry
the tool with finger on trigger,
the tool is able to fire a
fastener.
TOOL USE AND CARE
1) Use clamps or another
practical way to secure and
support the workpiece to a
stable platform. Holding the
work by hand or against the body
is unstable and is able to lead to
loss of control.
2
2) Do not force the tool. Use
the correct tool for the
application. The correct tool will
do the job better and safer at
the rate for which the tool is
designed.
3) Do not use the tool if the
switch does not turn the tool
on or off. Any tool that cannot
be controlled with the switch is
dangerous and must be
repaired.
4) WARNING – Disconnect
the tool from the air source
before making adjustments,
doing tool maintenance,
clearing jams, touching the
safety yoke, leaving work
area, unloading the tool. Such
precautionary measures
reduce the risk of injury to
persons.
5) Store the tool when it is
idle out of reach of children
and other untrained persons.
A tool is dangerous in the hands
of untrained users.
6) Maintain the tool with care.
Keep a cutting tool sharp and
clean. A properly maintained
tool, with sharp cutting edges
reduces the risk of binding and
is easier to control.
7) Check for misalignment or
binding of moving parts,
breakage of parts, and any
other condition that affects
the tool's operation. If
damaged, have the tool
serviced before using. Many
accidents are caused by poorly
maintained tools. There is a risk
of bursting if the tool is
damaged.
Publicidad
Tabla de contenido
