BraunAbility Turny Serie Instrucciones De Uso página 33

Troubleshooting
Hand control error messages
Message
No diode lit
1 Red blink
1
2 Red blinks
2
3 Red blinks
3
4 Red blinks
4
5 Red blinks
5
6 Red blinks
6
Alternating Red and Green
LEDs
Cause
The vehicle's engine is switched on and/
or the door is closed. Power supply
interrupted.
Power surge or pinch protection. Turny
stops with small amount of reverse
movement.
Potentiometer broken or disconnected.
Potentiometer/lift motor not moving.
Faulty switch for inwards- or outwards-
rotated position. Both affected
simultaneously.
Upper limit position broken, constant
fault.
Max limit for manoeuvring has been
reached, 180 seconds.
Upper limit position not affected, and max
outwards-rotation not affected. Turny
cannot be manoeuvred.
Actions
Switch off ignition and check that
fuse(s) and cable(s) are intact. For
further help contact your installer.
Check for obstacle(s) in the way.
Reactive Turny.
Contact your installation engineer.
Contact your installation engineer.
Contact your installation engineer.
Contact your installation engineer.
Contact your installation engineer.
Contact your installation engineer.
33
Turny
EN