Technical Data - Macrom 45.40 Manual De Instrucciones

RMS Power measured at 12.5 Volts DC:
Total maximum power
Front @ 1 kHz < 0.08 % THD into a 4 ohms load
Rear @ 1 kHz < 0.08 % THD into a 4 ohms load
Sub @ 50 Hz < 0.1 % THD into a 4 ohms load
Dynamic Power measured at 14.4 Volts DC:
Front @ 1 kHz < 0.1 % THD into a 4 ohms load
Rear @ 1 kHz < 0.1 % THD into a 4 ohms load
Sub @ 50 Hz < 0.1 % THD into a 4 ohms load
Front @ 1 kHz into a 2 ohms load
Rear @ 1 kHz into a 2 ohms load
Sub @ 50 Hz into a 2 ohms load
Crossover frequencies
High-Pass, Front/Rear
Low-Pass, Sub
Crossover slope
Frequency response ± 1 dB
Total harmonic distortion
Signal-to-noise ratio (IHF A-weighted)
Input sensitivity/Impedance at 12.5Volt DC
Speakers' impedance
Power supply
Weight
Size
Due to continuing improvement, the features and the design are subject to change without
notice.

TECHNICAL DATA

9
450 Watts
2 x 45 Watts
2 x 35 Watts
1 x 80 Watts
2 x 65 Watts
2 x 50 Watts
1 x 115 Watts
2 x 90 Watts
2 x 70 Watts
1 x 130 Watts
Flat, 63 or 80 Hz
50, 80 or 120 Hz
12 dB/Octave
10 - 50,000 Hz
0.08%
> 100 dB
200-4000 mV/20 kohms
2 ohms min
14.4 V DC (11-16 V allowed)
3.5Kg
217(l) x 49(h) x 370(d) mm