Functional Description - Milwaukee M18 0882-20 Manual Del Operador

• When battery pack is not in use, keep it away
from other metal objects like paper clips, coins,
keys, nails, screws, or other small metal objects
that can make a connection from one terminal
to another. Shorting the battery terminals together
may cause burns or a fire.
• Do not use damaged battery pack or vacuum.
If battery pack or vacuum are not working as
they should, have been dropped, damaged, left
outdoors,or dropped into water, return them to a
service center.
SERVICE
• Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
• Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
SPECIFIC SAFETY RULES
•Before using the vacuum, read this operator's
manual, your battery pack and charger opera-
tor's manuals, and all labels on the vacuum,
battery pack, and charger.
• Never use vacuum without dust canister and
filter in place. Never use water to clean filter.
• Wear ear protectors. Exposure to noise can cause
hearing loss.
READ AND SAVE
ALL INSTRUCTIONS
FOR FUTURE USE
SYMBOLOGY
Volts
Direct Current
Read operator's manual
Wear eye protection
UL Listing for Canada and U.S.
C US
SPECIFICATIONS
Cat. No. ..................................................... 0882-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Air Flow .......................................................40 CFM
Suction..................................................... 38 inH2O
FUNCTIONAL
DESCRIPTION
1
2
3
1. Inlet
2. Filter
3. Dust canister lid
4. Dust canister latch
5. Trigger
6. Lock-on switch
ASSEMBLY
WARNING
the battery pack before removing the dust can-
ister. Do not use tool without dust canister and
filter in place.
CAUTION
dependent on the filter. A dirty filter will reduce
the air flow and overall efficiency of the system.
Do not clean with water. Remove from dust can-
ister and tap clean or blow off with compressed
air.
Removing/Installing the Filter
To empty the dust canister:
1. Turn OFF the tool.
2. Remove the battery pack.
3. While holding over the trash, unlatch the dust
canister. Empty dust from the canister. Tap the
vacuum gently to dislodge any remaining dust.
4. To clean the filter, twist the filter counterclockwise to
unlock from the canister. Pull the filter away from the
vacuum and tap clean or blow off with compressed
air. Do not clean with water. Replace filter if dam-
aged or suction decreases (Single pack, Cat. No.
49-90-0160 or 2-pack, Cat. No. 49-90-1951).
To install the filter:
1. Twist the filter clockwise onto the dust canister.
NOTE: Do not operate the vacuum without the dust
canister and filter in place.
Installing/Removing the Accessories
To install the nozzles, hoses or extensions, push
the accessory onto the vacuum inlet.
3
5
4
To reduce the risk of
injury, always remove
Keep filter clean. Efficiency
of the vacuum is largely
6