Velleman HAMGSM133 Manual Del Usuario página 8

configuration SMS.
With the same phone used to make the first setup call, it is also possible to switch the relay
status.
Through SMS
This mode takes full advantage of the device with operations as output switch, output status
query, inclusion of additional phone numbers to activate the relay, inclusion of numbers for
door opening function, reception of reply messages; change output signals timing and, in
general, set the HAMGSM133 with all parameters via simple SMS. A full reset to restore the
default settings can also be made via SMS. The syntax for all available commands can be
found in §8 Configuration SMS.
Through USB (USB interface required, not incl.)
This mode easily allows you to setup the HAMGSM133 through a computer (with special
software) connected via an USB interface (not incl., Ref. HAMGSM133/USB).
It is possible to manage all programming and settings as well as change the list of enabled users.
This speeds up the initial set-up and saves on the cost of SMS. After starting the software,
verify that the communication speed is set to 9600 Baud (8, N, 1).
Refer to the full user manual for more information on the installation and use of the software.
Download the (English) software from
9. Configuration SMS
 Commands and settings can be sent from any mobile phone as long as the message includes the
password.
 For some commands a password is not required when the message was sent from a telephone
number which is stored in the HAMGSM133. However, some commands that change critical
information always require a password.
 The HAMGSM133 replies with a confirmation or information SMS.
 Multiple commands can be combined in 1 SMS by placing a comma in between.
Note: commands never contain spaces.
Refer to overview of all configuration SMS commands below.
Change password
Command: PWDxxxxx;pwd
Example: PWD54321;12345
Store numbers
Command: NUMx+YYnnnnnnnnnn;pwd
Example: NUM7+324851234567;12345
Number +324851234567 is stored on location 7 in the master list.
Remove numbers
Command: NUMx;pwd
Example: NUM5;12345
The number on location 5 is removed from the master list.
List stored numbers
Command: NUM?;pwd
Example: NUM?;12345
Show the master list.
15/12/2011
(password required)
xxxxx = new password (5 digits)
pwd = current password (default = 12345)
(password required for overwrite or from unknown phone)
YY = country code
x = position of the number in the list (1~8)
nnnnnnnnnn = phone number (max. 19 digits)
pwd = current password (default = 12345)
(password required)
x = position of the number in the list (1~8)
pwd = current password (default = 12345)
(password required)
pwd = current password (default = 12345)
HAMGSM133
www.velleman.be
8
© Velleman nv