Winding The Bobbin - EASYHOME MS-201 Manual Del Usuario

Winding the bobbin

Please Note: For safety precautions, always remove the bobbin from the Bobbin
Compartment (B).
1. Raise Thread Spindle (J) by grasping the notch on the top of the spindle and
pulling upward until thread spindle is fully extended.
2. Place thread on Thread Spindle (J).
3. Make sure the pin is extended out. If not, unlock the Hand Wheel Pin (X) by
pushing it in while simultaneously turning the Hand Wheel (W) clockwise
(away from you). Once the pin is released, turn the pin slightly clockwise to
lock it into place.
4. Pull thread from spool and place thread through the inside of one of the holes
in the bobbin to help keep it in place. Holding the end of the thread, wind
thread onto bobbin a few times, in the clockwise direction (away from you).
The wheel turns counterclockwise, so the bobbin needs to be threaded in the
opposite direction.
5. Push bobbin onto Hand Wheel Pin (X) to keep in place.
6. Slowly turn the machine on by pressing the Power Button (P) or using the Foot
Pedal.
7. Hold the thread lightly above the bobbin, guiding it gently through your
fingers.
8.
When the bobbin is full, turn off the machine.
10
User instructions