Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Warn the operator of the danger of blade thrust.
• Blade thrust may occur when the spinning blade
contacts an object that it does not immediately cut.
• A blade thrust can be violent enough to cause the
unit and/or operator to be propelled in any direction,
and possibly lose control of the unit.
• Blade thrust can occur without warning if the blade
snags, stalls or binds.
• Blade thrust is more likely to occur in areas where it
is difficult to see the material being cut.
• The handles and shield must be mounted according to the
instructions. Do not attach any blade to a unit without proper
installation of all required parts. Failure to use the proper parts
can cause the blade to fly off and seriously injure the operator
and/or bystanders. Discard blades that are bent, warped,
cracked, broken or damaged in any way. Use a sharp blade. A
dull blade is more likely to snag and thrust.
• The cutting attachment
may be spinning during carburetor
adjustments. Wear your protective equipment and observe all
safety instructions. Be sure the cutting attachment stops
turning when the engine idles. When the unit is turned off
make sure the cutting attachment has stopped before the unit
is set down. A coasting blade can cause injury while it
continues to spin after the engine is stopped when throttle
trigger is released. Maintain proper control until the blade has
completely stopped rotating.
WARNING:
IT IS UNSAFE TO USE ANY AFTER
MARKET HEAD,
ATTACHMENT,
ACCESSORY
OR BLADE ON THIS UNIT. USE
ONLY HEADS,
ATTACHMENTS,
BLADES AND ACCESSORIES
MANUFACTURED
BY SNAPPER
AND INTENDED
FOR THIS
SPECIFIC
MODEL.
•
TOOL LIST
•
Screwdriver (Phillips or Standard)
•
Allen wrench 4mm
•
lOmm wrench
•
17mm wrench
•
INSTALLING CUTTING HEAD
•
See Service/Adjustments
Sectionfor blade removal
instructions.
•
Make sure debris shieldwith line
cut off is properlyinstalled.See
ShieldAssemblySection.
•
Lockgear box (3) by insertinga
1/8 in. (4 ram)allen wrenchor
pinthru hole and finding
corresponding notch.
•
Installsplinedwasher (2) flat
side out.
•
To installhead (1), turn
counterclockwise. Hand-tighten
head securely.
•
To removehead, turnclockwise.
\
•
INSTALLINGTHE "J" HANDLE
•
Install the clamp assembly on
the shafttube.The top of the
clamp shouldtouchthe arrowon
the tube.Leave the screwsand
nutsslightlyloose.
•
PlaceJ handle inclamp as
shown-The J shape goes on
rightside of unit.Positionthe
handleuntilthe arrow on the
handletouchesthe edge of
the clamp.
•
Tightenthe screws.
•
THROTTLE-KILL
SWITCH
•
To accelerate unit hold down
lever (3) with the palm of the
RIGHT hand. Then squeeze the
trigger (2).
•
To return to idle. Release
trigger (2),
•
To stop the unit push switch (1)
forward.
•
To start the unit pull switch (1)
back.
•
SHOULDER HARNESS
•
Placethe strap over your left
shoulderand attachclipto
clamp eye on shafttube.
•
Loosenclamp screwand slide
clamp up or downuntil unit
balanceswith head justtouching
the ground.
•
Tightenscrew.
•
Noticequickreleasefeature.
Publicidad
Tabla de contenido
