General Description; Start Up - Helvi EXPLORER 120 Manual De Uso

• Warning ! Always disconnect from the mains before performing maintenance on the device.
• The device does not require any specific maintenance.
• If the internal fuse is melted, it must be replaced by the manufacturer (dedicated sales
service) or by an equally qualified person to prevent any accidents.
• Do not use solvents or any agressive cleaning products.
Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).
Waste management:
• This product should be disposed of at an appropriate recycling facility. Do not throw away
in a household bin.
Your Explorer 120 is a professional multifunctional charger with Inverter technology. Designed to support
the batteries of demonstration vehicles or during the diagnostic work, it also guarantees an ideal quality
of charge for the maintenance of the most advanced models. This charger can be fitted with cables up
to 8 m long. Changing the charging cables requires recalibration. It is considered a fixed device not a
mobile product.
Your Explorer 120 is supplied with a software that includes 4 different modes to choose from:
• Charging mode: dedicated to the charging of lead-acid (sealed, liquid, AGM...) or lithium (LiFePO4)
starter batteries.
• Power mode | Diag+ : Supplies the energy required during diagnostic work on the vehicle.
• Power mode | Showroom : Maintains the charge of the battery and supplies the energy required
when using the consumers of a demonstration vehicle.
• Tester Mode: Used to check the state of the battery and test the vehicle starting system and alternator.
Your Explorer 120 is SMART!
The original features of your Explorer 120 can be extended by adding specific charging modes and profiles
using the USB port and custom settings.
Your Explorer 120 also offers the possibility to recover data from several hundred charging operations on
your USB stick for analysis on a spreadsheet.
Additional modules (such as printer, Ethernet port, etc.) can also be connected to the charger via its
dedicated module socket.
Auto-Detect» function:
The Explorer 120 is equipped with the «Auto-Detect» function which automa-
tically starts a charge when a battery is connected to the charger.
Auto-Restart» function:
The «Auto-Restart» function offers the possibility of automatically restarting the charger in the event of
a power failure.
«Lock» function:
It is possible to lock the buttons on your Explorer 120 when it is used in a place open to the public or
unattended. To activate/deactivate the lock, press and hold
1. Connect the charger to the mains.
2. Set the switch, located at the back of the charger, to «ON».
3. Select the desired mode (Charge -> Showroom -> Diag+ -> Tester).
To access the «configuration» menu press the

GENERAL DESCRIPTION

START UP

key for 3s.
AUTO-DETECT
and for 3 seconds.
12V
U=12.3V
5