NODOR 4018 Manual Del Usuario página 35

minimum aperture between the 3 mm. contacts, dimensioned to bear the plate load and it must follow the standards
in force (the yellow/green earth cable must not be interrupted by the switch). The plug or omnipolar switch must be
easily reached on the installed equipment.
The manufacturers decline any responsibility in the event of non-compliance with what is described above and the
accident prevention norms not being respected and followed.
If the mains cable becomes damaged, replace it immediately with a cable or special cable set obtained from the
manufacturer or from after sales service.
The use of silicone for the sealing is prohibited. It is only permitted to use the seal provided.
The use of clay pots and heat diffusers is prohibited.
Adaptation to various types of gas
(Fig. 6) Should the appliance be pre-set for a different type of gas than that available, proceed as follows:
• replace the injectors (Fig. 6) with the corresponding type of gas to be used (see table "Injectors characteristics").
Fig. 6
• to adjust to the minimum, use a screwdriver on the screw placed on the tap (Fig. 8) after turning the tap to its
minimum position. For LPG (butane/propane) screw tight.
35