Cleaning coated or painted surfaces
Prolonged exposure to steam can cause wax,
furniture polish, plastic coatings or paint to
flake off and cause staining. Clean kitchen
and living room furniture, doors, parquet,
coated or plastic-coated surfaces only with
the microfibre cloth and do not wipe an area
too long, otherwise damage can occur, par-
ticularly on natural parquet and similar sensi-
tive surfaces.
Cleaning glass
Do not clean glass at low outdoor tempera-
tures. The hot steam can tension the glass
surface and shatter the glass.
Using the appliance
1. Insert the mains plug onto the mains
socket and switch on the the appliance using
the ON/Off switch (15), the power indicator
(2) lights up.
2. Press and hold down the steam release
lever (10 or 14).
3. To clean carpets, put the appliance onto
the carpet coasters (see image C2).
4. Slowly push the appliance over the sur-
face to be cleaned.
After using
1. Switch off the appliance using the ON/
OFF switch (15) and pull the plug out of the
mains socket.
2. Allow the appliance and the used acces-
sories parts to cool down completely.
3. Remove the cloth from the nozzle or floor
brush.
4. Empty the water tank.
Using the accessories
Adapter/spot spray nozzle
The closer you hold the nozzle to the dirty
surface, the better the cleaning effect since
the temperature and steam pressure are at
their highest directly at the nozzle outlet.
The adapter can also be used as a spot
spray nozzle or with the following attach-
ments:
Joint brush (24),
Round brush (18)
Fabric brush (23)
Angled adapter (19)
Flat scraper (20)
Joint brush
Use the joint brush for cleaning joints, floor
tiles or edges.
Round brush
Use the round brush for cleaning hotplates
and benches.
Steam very dirty areas thoroughly and allow
them to soak for a while. This removes dirt
more easily.
Fabric brush
The clothes brush is suitable for steaming
hanging clothing as well as cleaning windows,
mirrors, ceramic tiles and other smooth sur-
faces.
Rinse the microfibre cloth at regular intervals
to improve absorption of dirt.
Angled adapter
Use the angled adapter to clean corners and
locations that are difficult to access.
Flat scraper
Use the flat scraper for cleaning hard sur-
faces.
Window attachment
1. Wipe the glass surface from top to bottom
with the rubber lip.
2. Wipe the rubber lip and the lower edge of
the window dry with a cloth after each row.
Floor brush
The floor brush is suitable for cleaning large
washable wall and floor coverings. It can be
used with or without a cloth.
Move the floor brush rapidly back and forth
after discharging the steam. To clean joints
properly, move the floor brush diagonally to
the joint.
Rinse the microfibre cloth or the coral cloth at
regular intervals to improve absorption of dirt.
EN 15