Operating Instructions - wolfcraft LC 250 Instrucciones De Uso

This laminate cutter is only suitable for, and hence must only be used for, cutting laminate with a maximum
width of 21.0 cm by hand, where the MDF/HDF board has a thickness of 11 mm + impact sound insulation.
The blade of the laminate cutter is made of wear-free material. Due to its special shape, the cutting blade must
not be ground or sharpened.
Re-tighten the screwed connection at the blade clamping, if necessary.
Please refer to the illustrations on pages 2 - 6 for the installation and the operation of the appliance.
Hint: If you like to cut thicker laminate, it is helpful to connect the product by using the integrated screws
to a wooden board. This will bring additional stability to the Laminte Cutter.

Operating instructions

1. Raise the cutting blade with the handle upwards
2. Push the laminate board against the guide edge, so that a precise cutting angle of 90° will be created.
Hint: Support the other end of the laminate board, so that it will be pushed horizontally against
the guide edge.
3. A clean cut is achieved by pressing the cutting blade with the handle steadily downwards.
Please make sure to push the blade straight down, in order to get an optimal result.
4. Attention: Remove the angle stop before making angular & longitudinal cuts (e.g. for the end boards).
Safety instructions:
• Operate the appliance only by using its handle; keep your fingers off the cutting area.
• Always operate the appliance alone!
• Leave the blade in its closed position, when the appliance is not in use. When opening the blade move it right
to the limit stop at rear.
• Do not make any modifications or changes to the appliance.
• Never sharpen the blade!
• Make sure that both you and the appliance have a safe position on a stable surface.
• Check before starting to work that the equipment used is properly installed (such as screwed connections).
• Make sure your clothing fits tightly (especially the sleeves) and that you wear eye protection.
• Keep children out of your workshop and store your equipment and tools in a secure place.
• Never let inexperienced personnel work with your equipment and tools without duly supervising and
instructing them.
• Always work methodically, in a concentrated fashion and with sufficient lighting.
Guarantee
We provide a warranty of 10 years from the day of purchase on the wolfcraft
it is exclusively used for DIY purposes. The warranty only covers damage to the item purchased, and only such
damage that can be attributed to faulty material und poor workmanship. The warranty does not cover defects
and damage that must be attributed to improper use or insufficient maintenance. Nor does the warranty cover
the usual wear and tear as well as defects and damage, of which the customer has been aware
when purchasing the equipment.
Warranty claims can only be asserted by producing the invoice or the till receipt.
The warranty granted by wolfcraft
performance, withdrawal from the contract, price reduction, claims for damages or reimbursement
of expenses).
t
Laminate cutter
does not in any way restrict your statutory consumer rights (i.e. contract
®
8
product you acquired, provided
®