Swann SW233-WDM Manual Del Usuario página 11

Do not store in very cold areas. When the system warms up (to its normal
temperature), moisture can form inside the case, which may damage electronic
circuit boards.
Do not attempt to open the case. Non-expert handling of the device may
damage the system.
Avoid dropping or strong shocks.
Operate this product using only with the power supply included or provided as
an accessory.
Do not overload electrical outlets or extension cords this can result in fire
or electric shocks.
Do remember that you are using public airwaves when you use the system
and that sound and video may be broadcast to other 2.4 GHz receiving devices.
Conversations, even from rooms near the camera, may be broadcast. To protect
the privacy of your home, always turn the camera off when not in use.
Specifications
Camera
Frequency
Antenna
Transmission distance
Modulation
Image Sensor
Lens
IR LED
Dimensions
Weight
Power
Operating temperature
Specifications subject to change without notice
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
FCC Label Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
Such modifications could void the user's authority to operate the equipment.
2.4 GHz
Dipole antenna
150 M (Line of Sight)
FSK, FHSS
Color CMOS image sensor
f 6.0mm, F 2.0
9 pcs
8.9(W) x 10.7(H) x 8.2(D) cm;
Without stand
175g
DC 6V, 800mA or 4 AAA batteries
0 ~ 40 (32 ~ 104 )
Monitor
Frequency
Antennas
Modulation
Display
Display colors
Brightness Control
VOX
Dimensions
Weight
Power
Operating temperature
2.4 GHz
Dipole antenna
FSK, FHSS
2.36" TFT LCD
Full-color
5 steps
Voice activation
6.6(W) x14.5(H) x 4.1(D) cm
120g
DC 6V, 800mA or Li battery
0 ~ 40 (32 ~ 104 )
0678
5