Peach PS500-60 Manual De Instrucciones página 9

Paper guide
12
Paper cassette
13
Bin for CD rubbish
14
Retaining collar for
15
Operation
Paper shredder setup
Place the paper shredder on the waste-
paper basket
8
Plug the mains plug into a properly in-
stalled socket (230 V, 50 Hz).
Flip the paper feed cover
Note: You may shred up to 5 sheets of
size A4 paper (80 g / m
the blade opening
paper feed and shred up to 50 sheets
2
size A4 paper (80 g / m
Note: Always insert smaller pieces of
paper such as envelopes or receipts in
the middle of the blade opening
Install paper cassette and bin for
CD rubbish
Slide the paper guide
guides of the paper cassette
above (see Fig. B I-III). Then slide the
assembled paper cassette into the chute
(Fig. B-IV).
2
IMPORTANT! Be sure the insert the pa-
per cassette before starting the device!
Switch off the device and unplug from
the mains. Remove the cutting unit by
the handle and turn over. Slide the bin
for CD rubbish
14
collars (Fig. C).
15
Note: The bin for CD rubbish
cantly reduces the capacity of the paper
bin. Therefore only use as needed or if
you absolutely wish to separate the CD
rubbish from paper waste.
Using auto mode
Set the shredder AUTO / OFF / REVERSE
switch to "AUTO". The motor will start
4
automatically when paper is inserted.
The power light
14
so it rests on the edge.
up.
1
) at once using
2
. You may fill the
3
).
2
.
3
into the side
12
from
13
into the two retaining
signifi-
14
will light up green.
6
Adding paper
When paper to be shredded is inserted
into the paper cartridge
will automatically start shredding. You
can also remove the paper cartridge
collect paper to be shredded in it (offline)
and shred as needed.
Shredding CDs
Shred CDs by adding them to the sepa-
rate cutting opening
Clearing jams
If the paper cartridge
paper added, remove from the cassette.
Remove any paper clips, staples or crum-
pled up paper (also see Fig. D). Then add
the paper again and set the switch
position "AUTO".
In the event of a jam, slide the AUTO /
OFF / REVERSE switch
SE" position (reverse). Then set the
AUTO / OFF / REVERSE switch
"AUTO" position (forward). This will clear
the jam.
When necessary, you can alternatively
open the paper guide by turning the me-
chanism and remove jammed paper.
11
Preventing jams and overloading
The paper shredder features a motor overload
protection. A cycle corresponds to about
5 minutes at a maximum load of 50 sheets.
The device will automatically switch off when:
– Exceeding the maximum capacity of 5
sheets (in the cutting opening
sheets of paper (in the paper chute
or not inserting the paper centred in the
cutting opening. The Power / Overload
light will light up red.
– Continuously using the device for more
than 5 minutes at maximum capacity. The
Bin Full / Overheat
– The waste bin is full. The Bin Full / Over-
heat light will light up blue.
7
the device
13
13
.
9
does not feed the
13
4
to the "REVER-
4
to the
4
) or 50
3
2
light will light up red.
7
9
,
to
)
6