Programming Example; Programming The Stick Positions - ROBBE ROXXY BL-CONTROL OPTO 900 SERIE Manual De Uso

4.3 Programming example

In the following example, the setting up of the controller will be made with the stick positions method and followed by the programming of
the model type: AIR (power model) and brake ON used as an example.

4.3.1 Programming the stick positions

1. Switch the transmitter on, and move the throttle stick to the "forward" position.
2. Connect the drive battery to the speed controller (unit emits a brief beep).
3. After about ten seconds a double series of beeps confirms that it has detected the "stick forward" position.
4. Move the throttle stick to the "stop" position. A brief series of beeps confirms that the controller has detected the "stop" position.
5. Disconnect the drive battery from the speed controller.
4.3.2 Programming the controller parameters
1. Switch the transmitter on, and move the throttle stick to the "forward" position.
2. Connect the drive battery to the speed controller (unit emits a brief beep).
3. After about ten seconds you will hear a double series of beeps, followed by a triple series of beeps after a further three seconds.
4. The controller is now in programming mode for Parameter 1 (continuous single beeps and LED flashes).
5. Select Parameter 4 by moving the throttle stick four times from the "forward" position to the "stop" position and back to the "forward"
position again (continuous quadruple beeps and LED flashes).
6. To change the parameter you must first move the throttle stick from the "forward" position to the "stop" position, leaving the throttle stick at
the "stop" position for at least three seconds.
7. Select the "Air" mode (beep sounds / LED lights up every two seconds).
8. The change is stored by moving the throttle stick from the "stop" position to the "forward" position.
4.3.3 Setting Air Brake On
1. When you have stored the setting as described above, the speed controller returns to parameter select: Parameter 4.
2. Select Parameter 3 by moving the throttle stick four times from the "forward" position to the "stop" position and back to the "forward"
position again (continuous triple beeps and LED flashes).
3. To change the parameter you must first move the throttle stick from the "forward" position to the "stop" position, leaving the throttle stick at
the "stop" position for at least three seconds.
4. The controller now displays the currently set brake function: Air Brake ON (beep sounds / LED flashes every 0.5 seconds) or Air Brake OFF
(beep sounds / LED lights up every two seconds). If you wish to change the parameter, move the throttle stick rapidly from the "stop" position
to the "forward" position and back.
5. The change is stored by moving the throttle stick from the "stop" position to the "forward" position.
6. Disconnect the speed controller from the drive battery.
Operating Instructions
Roxxy BL-Control 900 series Opto
10