Connecting The Transmitter To An Audio Device; Putting On The Headphones; Operating The Headphone System; Adjusting The Range Of The Transmitter - Blaupunkt Comfort 112 Wireless Instrucciones De Manejo

Connecting the transmitter to an audio device

The transmitter can be connected to diff erent audio devices, such as portable players, TV
sets, stereo systems or computers.
u Switch off the audio device before connecting the transmitter.
Connection to audio devices with jack socket
u Connect the audio cable with the jack socket of the transmitter.
u Connect the audio cable with the headphone jack of the audio device. If the audio
device has a 6.3-mm headphone jack, use the supplied 3.5/6.3-mm audio adapter.
Connection to audio devices with cinch sockets
u Connect the audio cable with the jack socket of the transmitter.
u Plug the supplied cinch adapter onto the audio cable and connect the red cinch plug
to the right channel (red) and the white cinch plug to the left channel (white) of the
audio device.
Connection to audio devices with USB port
u Connect the USB cable with the USB port of the transmitter.
u Connect the USB cable with the USB port of the audio device.
Note:
If the transmitter is connected with a headphone jack and a USB port at the same
time, the sound signal is transmitted via the headphone jack. In this case, the USB
port is used to charge the battery in the transmitter.

Putting on the headphones

For a good sound quality and a convenient fi t, the headphones must be positioned per-
fectly.
u Put on the headphones. When putting on the headphones, observe the markings
L and R to identify the left and right earpiece.
u Adjust the headphone band so that the ear cushions completely enclose the ear and
the headphones rests comfortably on the head.
18

Operating the headphone system

To listen to music with the headphone system, proceed as follows:
u Switch on the audio device and start the music playback.
Note:
Adjust the volume level at the audio device as high as possible without having a
distorted sound. If the volume level is set too low, the sound quality may be impaired
due to noise.
u On the transmitter, hold the
button pressed for 3 seconds.
The transmitter switches on. The power-on indicator lights blue if the transmitter
receives sound signals.
u On the headphones, hold the
button pressed for 3 seconds.
The headphones switch on and the power-on indicator fl ashes green. The power-
on indicator lights as soon as the headphones receive the sound signal from the
transmitter.
u Use the VOL
control to adjust the volume of the headphones to the desired
value.

Adjusting the range of the transmitter

You can adjust the range of the transmitter with the LO/HI switch. The maximum range
between transmitter and headphones depends on the ambient conditions and the
charging state of the battery.
u Select the LO setting for a maximum range of up to 10 metres.
- Or -
u Select the HI setting for a maximum range of up to 30 metres.
Note:
With the HI setting, the power consumption is higher so that the operating time of
the battery is reduced.

Switching off the headphone system

Switch off the headphone system after use to save the batteries and the rechargeable
battery.
u On the headphones, hold the
button pressed for 3 seconds.
The headphones switch off and the power-on indicator goes out.
u On the transmitter, hold the
button pressed for 3 seconds.
The transmitter switches off and the power-on indicator goes out.
Note:
If the transmitter or the headphones do not receive a sound signal for more than
10 minutes, the headphone system automatically switches off .
19