Auto-Hold Function; Switching The Weight Display; Automatic Switch-Off/Economy Mode; Taring Weight Display (Tare) - Seca 952 Manual De Instrucciones

Auto-hold function

The HOLD function is activated automatically at weights of over 1.5 kg. The display flash-
es until a stable weight has been measured. The display is then frozen until the next
weighing operation. HOLD appears in the display.
– To perform a new measurement with-
out removing the load from the scale
first, press the hold/tare key.

Switching the weight display

The weight display can be switched between kilogrammes (kg), pounds (lb) and stones
(st).
– Switch on the scale using the start key.
Weight is initially displayed in the last
setting selected.
– To switch the weight display between
kilogrammes, pounds and stones, keep
pressing the kg/lb/st key until the de-
sired unit appears in the display.
– The kg, lbs or sts display lights up.

Automatic switch-off/economy mode

The scale switches off automatically after approx. 3 minutes if it has no load on it. If the
tare or hold functions are activated, the scale switches off after approx. 2 minutes. If the
scale has a load of at least 2 kg on it, it does not switch off for approx. 2 minutes.

Taring weight display (TARE)

The Tare function is very useful if an additional weight (a blanket, for example) is to be
ignored for weighing purposes.
Proceed as follows:
– Press the start key with no load on the
scale.
– First place the additional weight (a blan-
ket, for example) on the scale and acti-
vate the Tare function by depressing
and holding the hold/tare key.
Model 952
0. 0
kg
0:00. 0
sts
0. 0
lbs
GB
17